HOW to use the PEEL N STICK

Ziegler's Embroidery Supply

Quality Products at affordable prices

YOU hoop a piece of STICKY

or PEEL N STICK Tear away STABILIZER in the hoop by itself.

With the RELEASE Paper side up and the tear away side on the bottom.

Tighten your hoop

Take a pin or a pre-used needle

and lightly score the paper, I usually mark it with an X, Be careful not to score thur both layers,

Now use the edge of your pin and

lift an edge so you can pull it back.and tear it away.

I completely expose the sticky side.

I know some of you stick the sticky right to your hoops, that's ok if that is all you ever use that hoop for, but the tacky stuff on the hoop is a mess to clean.

(Use rubbing alcohol, or AVON's SSS

Skin so Soft OIL, then wash with warm soapy water)

IF you own the HOOP IT ALL HOOP, you simply cut to fit so it will overlap the edge sightly if possible. Now pull a corner of the release paper back, I usually expose about a strip aong the

top about 1 " wide, stick it to the top edge of the hoop and then pull the release paper back

while setting the sticky side to the hoop as I go.along.

CLIP your hoop to the MACHINE.

LAY the part of the garment on that you want to sew.

Use your trial run buttons or tracing buttons to see where it will be on the item and then sew.

REMEMBER not to use your AUTOMATIC Needle threaders when using the sticky paper.

THREAD the old fashioned way.

You'll be glad you did, and if you don't and you mess up the needle threader you'll wished you would have done it the old fashioned way.

But its really your choice, I know those needle threader's spoil you fast, how did we ever sew without them.

When your done, gently tear the Garment off, trying to leave as small a hole as possible, because you can cut another small piece of sticky a little larger than the hole and and then stick it on there, to cover the hole, like a bandaid of sorts, and you can use that piece again.

Hey you have to save where you can.